20
Figure 11-2
8. Use a rubber mallet, or hammer against a
block of wood, to tap spindle toward tailstock
(Figure 11-3). Note: The right side bearing will
slide out with the spindle.
Never use a steel face
hammer directly against the spindle.
Figure 11-3
9. Continue pulling spindle toward tailstock until it
clears left hole in headstock and offers enough
room to remove belt (Figure 11-4).
10. Remove belt through lower access door.
11. Reverse above procedure to install belt and re-
position spindle.
Figure 11-4
NOTE: Make sure when reinstalling:
• to place cover (D, Figure 11-2) onto
spindle before inserting spindle into
headstock.
• to insert spindle lock with its spring (E,
Figure 11-2) before tightening cover.
• that right-side bearing is properly seated in
its recess in the headstock.
• that spindle pulley is aligned with motor
pulley.
• not to overtighten handwheel.
11.3 Additional servicing
Any other servicing should be performed by an
authorized service representative.
To Next Page
Loading...
