7
5.0 Specifications – JWL-1221SP lathe
Table 1
Model number
JWL-1221SP
Stock number 719115
Motor and electrical
Motor type totally enclosed fan cooled, induction, capacitor start
Horsepower 3/4 HP (0.56 kW)
Phase 1 PH
Voltage 115 V
Cycle 60 Hz
Listed FLA (full load amps) 6.7 A
Starting amps 14.5A
Running amps (no load) 5.8A
Running capacitor
40μF 250VAC
Power transfer belt
On/off switch Paddle style with safety key
Motor speed (no load) 1720 RPM
Power cord 3x16AWG, 6 ft. (183 cm), 10A plug
Recommended circuit size
1
10A
Sound emission
2
73 dB at 20 inches (508mm) from motor
Capacities
Swing over bed 12.5” (318 mm)
Swing over tool rest base 9.45” (240 mm)
Distance between centers 20.5” (520 mm)
Faceplate diameter 3” (76 mm)
Headstock
Spindle taper MT2
Spindle thread 1”- 8TPI
Spindle bore 3/8” (9.5 mm)
Number of spindle speeds 6
Spindle speeds 380, 940, 1400, 1810, 2550, 3975
Number of indexing positions 24
Tailstock
Quill taper MT2
Maximum quill travel 2-1/4” (57 mm)
Hole through tailstock 3/8” (9.5 mm)
Main materials
Bed cast iron
Headstock cast iron and steel
Tailstock cast iron and steel
Tool support cast iron
Tool support base cast iron
Dimensions
Bed width 6-5/8 in. (168 mm)
Bed gap 1-1/4 in. (32 mm)
Height, floor to spindle centerline 14.75 in. (375 mm)
Base footprint 30-1/2”L x 9”W (775 x 229 mm)
Tool support post diameter 5/8” (15.9 mm)
Overall dimensions, assembled (LxWxH) 33.6”L x 11”W x 17.7”H (853 x 280 x 450 mm)
Shipping carton dimensions (LxWxH) 35.82”L x 14.56”W x 21.25”H (910 x 370 x 540 mm)
To Next Page
Loading...
