8. Maintenance and inspection
General notes:
Maintenance, cleaning and repair work may only be
carried out after the machine is protected against
accidental starting by pulling the mains plug.
Check sanding belts regularly for faults. Replace a defective
sanding belt immediately.
Inspect the blade tracking regularly.
Take away the belt tension if the machine is not in use for a
longer period.
Clean the machine regularly.
Inspect the proper function of the dust extraction daily.
Defective safety devices must be replaced immediately.
All protective and safety devices must be re-attached
immediately after completed cleaning, repair and
maintenance work.
Repair and maintenance work on the electrical system may
only be carried out by a qualified electrician.
9. Trouble shooting
Motor doesn’t start
*No electricity-
check mains and fuse.
*Defective switch, motor or cord-
consult an electrician.
*Overload has reacted-
Wait and reset overload cut-off.
Sanding belt slips
*Sanding belt is stretched-
install new sanding belt.
*Too much applied pressure
move work piece while sanding.
Machine vibrates excessively
*Stand on uneven floor-
adjust stand for even support.
*motor mounts are loose-
tighten motor mount bolts.
Abrasive belt keeps tearing
*Belt is running the wrong direction-
observe arrow on the sanding belt
Sanded edge not square
*Table not square to sanding platen-
Adjust positive stop for 90.
Sanding marks on the wood
*Work piece was held still-
keep work piece moving.
*Wrong grit sanding belt-
use coarser grit for stock removal
and fine grit for finish sanding.
*Feed pressure too high-
never force the wood.
10. Environmental protection
Protect the environment.
Your appliance contains valuable materials which can be
recovered or recycled. Please leave it at a specialized
institution.
This symbol indicates separate collection for electrical and
electronic equipment required under the WEEE Directive
(Directive 2012/19/EC) and is effective only within the
European Union.
11. Available accessories
Stock number 60-0505
Abrasive belt cleaning stick
Stock number 708118
Mobile base up to 250kg
Refer to the JET-Pricelist
for various grit sanding belts.
To Next Page
Loading...
