Jet ProShop II - Page 10

10
Dust collection
Dust port outside diameter
4 in. (102 mm)
Recommended minimum extraction volume
400 CFM (0.5 CMM)
General Dimensions
Base footprint
23-1/2 x 24-1/2 in. (597 x 623 mm)
Assembled, with 30-in. rail set, L x W x H
60 x 40 x 43 in. (1524 x 1016 x 1090 mm)
Assembled, with 52-in. rail set, L x W x H
82 x 40 x 43 in. (2083 x 1016 x 1090 mm)
Shipping dimensions, saw only, L x W x H
30 x 29-3/4 x 29 in. (76 x 75.5 x 74.5 cm)
Weights
Saw only without wings – net weight
253 lbs (115 kg)
248.6 lbs (113 kg)
Saw only without wings – shipping weight
283.3 lbs (129 kg)
279.5 lbs (127 kg)
1
subject to local/national electrical codes.
2
The specified values are emission levels and are not necessarily to be seen as safe operating levels. As workplace
conditions vary, this information is intended to allow the user to make a better estimation of the hazards and risks
involved only.
L = length, W = width, H = height, D = depth
n/a = not applicable
The specifications in this manual were current at time of publication, but because of our policy of continuous
improvement, JET reserves the right to change specifications at any time and without prior notice, without incurring
obligations.