How to fix a slipping and noisy starter unit on my JetCat P80 Toy?
If the starter unit on your JetCat Toy slips and makes noise, it's likely due to dust and oil sediment on the compressor nut and O-ring. Clean the O-ring and compressor nut periodically with a cotton swab and solvent.
How to align ECU to the R/C system on JetCat Toy?
If the ECU doesn't follow full commands from the throttle stick on your JetCat Toy, it might be due to a programming alteration in the R/C transmitter. Check alignment with the RC-Check menu and re-align the ECU to the R/C system.
Details fuel tubing, filters, pump connections, and system priming.
Procedure to calibrate the temperature probe for ECU updates and accuracy.
Steps for setting up failsafe mode and learning the RC system.
Configuration steps for enabling and using single channel RC operation.
Step-by-step guide for initiating turbine startup and running procedures.
Instructions for starting the turbine directly from the GSU unit.
Describes the immediate manual shutdown process for the turbine.
Details the automatic turbine shutdown sequence.
Allows adjustment of turbine parameters within specified allowable values.
General| Thrust | 80 N |
|---|---|
| Exhaust Gas Temperature | 500 - 750 °C |
| Fuel | Kerosene |
| Lubrication | 5% synthetic oil in fuel |
| Maintenance Interval | 25 hours |
| Type | Turbine |
To Next Page