IMPORTANT: ENSURE THAT NO WIRING IS VISIBLE AND EXPOSED OUTSIDE OF THE FRONT GUARD AND STEERING WHEEL
STEM.
7. POSITION THE STEERING WHEEL SUCH THAT THE HOLES IN THE SIDES OF THE STEERING WHEEL STEM ARE ALIGNED WITH THE
HOLES OF THE STEERING ROD.
8. FROM THE RIGHT SIDE, INSERT THE BOLT THROUGH THE HOLES IN THE STEERING WHEEL STEM BY TWISTING IT IN CLOCKWISE
UNTIL THE TIP EMERGES ON THE LEFT SIDE.
9. TWIST THE NUT CLOCKWISE ONTO THE TIP OF THE BOLT. HOLD THE NUT STEADY WHILE YOU TIGHTEN THE BOLT INTO IT BY
TURNING THE BOLT CLOCKWISE WITH THE PHILLIPS-HEAD SCREWDRIVER.
BOLT
STEERING WHEEL STEM
PHILLIPS-HEAD
SCREWDRIVER
NUT
8
9
To Next Page
Loading...
