Jetson Volt X - Assembling the Steering System

27
YOU WILL NEED THE PHILLIPS-HEAD SCREWDRIVER.
1. HOLD THE PRE-INSTALLED NUT(SIZE M5) ON THE
STEERING WHEEL STEM STEADY. LOOSEN AND REMOVE
THE PRE-INSTALLED BOLT(SIZE M5 X 55MM) BY TWISTING
IT OUT COUNTERCLOCKWISE WITH THE PHILLPS-HEAD
SCREWDRIVER. SET THE BOLT AND NUT ASIDE.
2.6 Assembling the Steering System
BOLT
STEERING WHEEL STEM
PHILLIPS-HEAD
SCREWDRIVER
NUT
STEERING WHEEL (F)