68 69
STORAGE TRANSPORT
|6| STORAGE
SHORT-TERM STORAGE
For short-term storage, for example between the individual days of riding, it is sucient to follow the
steps described in the chapter on page 64 “AFTER THE RIDE”. After these steps have been performed,
store the JetSurf in a dry place.
LONG-TERM STORAGE
If the break is longer than one week, it is necessary to perform other tasks. Do not underestimate these
steps. Keep in mind that if you look after the JetSurf properly, you will increase the life of all its parts.
For at least 3 days always start the engine and accelerate several times.
Take the fuel tank out of the board. Pour all fuel out of the fuel tank and clean it thoroughly.
Never store the Jetsurf with fuel in the tank.
Always once in every 6 months, grease all the engine parts with MOTOREX INTACT MX 50 spray.
In winter or when JetSurf is not used, it is necessary to charge the batteries in ICU at least once in
every 3 months. For battery charging, see page 46.
Check grease in the freewheell, see page 73 Freewheel.
|7| TRANSPORT
NEVER TRANSPORT JetSurf
TM
WITHOUT FIRST EMPTYING THE FUEL TANK.
FUEL CAN BE REMOVED ONLY ON-SHORE AND PROPERLY AS DESCRIBED IN
THE FUEL SECTION OF THIS OWNER’S MANUAL PAGE 32. TRANSPORTING
FUEL CAN BE DANGEROUS AND MAY BE ILLEGAL IN SOME JURISDICTIONS.
Before transporting the power board, make sure that there is no water in the exhaust system. It
could get into the engine during the transport (see the chapter After the ride).
Always unscrew both side and main ns.
NOTE: If you have a two-part main n, you can keep the platform on the board and unscrew only
the spike.
We recommend to transport JetSurf without the fuel tank inside the board.
AIR TRANSPORT
Airline companies do not like fuel in luggage and it might happen that they could refuse to transport
your power board. Therefore it is ABSOLUTELY NECESSARY to wash the fuel tank completely before
air transport of your power board. Wash the tank with water and detergent. Repeat washing as long
as you can still smell petrol from the fuel tank.
Before air transport also check the excess pressure tube (blue tube coming out of the fuel tank to
the snorkel outlet in the board tip), there can be traces of fuel there. If there are remnants of fuel in
the tube, wash this tube out.
Please be aware of how airline companies treat the luggage. Despite its solidity, carbon is still quite a
brittle material and therefore it is not enough to pack the power board in the original Jetsurf bag but
you have to add other protection layers.
TRANSPORT TO SERVICING
Before transport, place the power board in the original board bag and add further protection layers
(for example wrap the board bag with the power board in bubble wrap and wrap it all in stretch foil
or insert the bag in a carton box).
Apart from a name tag and contact details, we recommend enclosing a detailed description of the
problem.
Note: If you are sending your Jetsurf to servicing back to your dealer or directly to the manufac-
turer, you do not have to send all the accessories together with the power board (e.g. the tank, ns
or charger… ).
WE RECOMMEND TO CONTACT AND COMMUNICATE WITH A SERVICE POINT FIRST!
WARNING
To Next Page
Loading...
