27
To enable MAC Filtering,
1. Select ON.
2. Press Add to add a line to enter permitted device name and MAC address, then click
OK. When entering MAC addresses, use “:” as the separators (for example,
c2:b5:d7:27:fb:9b). To add more, press Add to add another line.
3. When completed adding devices, press Save Changes.
NOTE: Once MAC filtering is set up, only listed device can access your router’s Wi-Fi
network. The MAC filtering has no effect on devices connected via Ethernet connection.
- Firewall IPv4
You may set up firewall rules to protect your network from virus and malicious activity on the
Internet.
- Firewall Switch – To set up Port Blacklist and Port Forwarding, turn Firewall Switch
ON. If Firewall Switch is OFF, both Port Blacklist and Port Forwarding settings are
not active.
- Port Blacklist – You can block outbound forward packet by setting up a rule in the
blacklist. To set up the rule,
1. Turn ON Port Blacklist.
To Next Page
Loading...
