Note: The remote control must be calibrated when using or replacing the remote
control for the first time.
Click the "Joystick Calibration" button to start the joystick
calibration. Turn on the remote control at the same time, and move
all the joysticks of the remote control back and forth between the
maximum and minimum positions, and confirm that channels 1 to 4
of the remote control are roll, pitch, throttle, and yaw
respectively. After calibration, return 1 ~ 4 channels of the remote
control to the middle position, and then click the “Calibration End”
button.
3) .Flight mode setting
The 5 channels of the remote control are used to map the flight
mode. Three flight modes can be set in the K ++ assistant software:
ATT (attitude mode), manual operation (GPS mode), and AB
execution (AB operation mode). Subsequent chapters will explain
each flight mode in detail. By default, the three positions of the 5
channels are all ATT mode. The user can click the drop-down menu
to the right of the three positions to select another mode.
4). Runaway protection settings
Runaway protection is used to set the flight behavior of the remote
control when it is out of control, including automatic return,
automatic landing, automatic hovering and landing after hovering.
5). Run out of control to continue route setting
When the out-of-control continue operation option is enabled, the
out-of-control protection will not be performed after the remote
control is out of control in the operation mode (AB operation, route
operation), but the operation task will continue to be performed. It
is recommended to use this function with the radar.
To Next Page
Loading...
Need help?
General
