noise increases significantly, then fine-tune the sensitivity back to normal
conditions.
c. Then adjust the roll / pitch correction sensitivity, press 10% slowly from low to
high, until the aircraft shakes, the motor sound is abnormal or exaggerated, and
then adjust the sensitivity back to normal conditions.
d. Finally adjust the yaw sensitivity. In general, if the default parameters do not
appear to lock the head, you do not need to adjust it. If the head does not lock,
increase the sensitivity.
2). Motor idle speed selection
It is used to set the idle speed of the motor after the aircraft is
unlocked. Disabled means not to rotate. From very slow to fast, it
means that the speed that can be reached by clicking is faster.
3). Motor sequence detection
Used to test the rotation direction of the motor. When using this
function, connect the power battery and remove the propeller.
After clicking the circular buttons M1
～
M4, the corresponding
motor will rotate at idle speed. Please ensure that the motor serial
number, steering and diagram are consistent.
4 Remote control settings
Click to enter the basic interface of the assistant software, and
select the remote control in the upper menu bar. As shown in the
figure, you can select the remote control type, remote control flight
mode channel settings, and runaway protection settings according
to actual requirements.
1) .Remote control type
K ++ flight control currently supports SBUS type remote control.
2) .Remote control calibration
To Next Page
Loading...
Need help?
General
