For detailed operation, please refer to the APP instruction manual.
5.Auto return mode
The auto return mode provides safety guarantee for long distance
flight and runaway protection.
1). Working conditions
After the star search is completed and the positioning accuracy
reaches the requirements (the red LED does not flash or the red
light flashes only once), the flight controller will automatically
record the current position as the home point each time the user
unlocks. After entering the auto return mode, the green LED
flashes quickly.
2). Operating instructions
The auto return mode can be triggered by the joystick or by
runaway protection. When the remote control CH6 mode switch is
set to the one-touch return position or the flight control enters the
out-of-control protection, if the aircraft is more than 2 meters away
from the return point, the aircraft will automatically rise to the set
altitude (if the current altitude is greater than the set return altitude,
press Return to current altitude). After reaching the return point,
the aircraft will first hover in the air for about 3 seconds and then
land slowly. At this time, the flight status of the aircraft can be
controlled by the remote control joystick (but the throttle lever
does not work), making it easier for the aircraft to find a more
suitable landing. point. After the aircraft has fully landed, the
aircraft will automatically lock. If the aircraft is less than 2 meters
from the home point, the aircraft will land in place and lock
automatically.
Precautions:
The premise of automatic return is that the return point of the aircraft has been
recorded. If you need to use the automatic return, please unlock it after the GPS
search is completed. Please refer to the appendix LED three-color light for status
and meaning.
When the aircraft is close to people, it is recommended not to switch to the auto
return mode to avoid accidents.
To Next Page
Loading...
Need help?
General
