To Next PageTo Next Page
Need help?Do you have a question about the Johnson Controls B1HA036 and is the answer not in the manual?
General| Cooling Capacity | 36000 BTU/H |
|---|---|
| Heating Capacity | 36000 BTU/H |
| SEER | Up to 16 |
| Refrigerant | R-410A |
| Power Supply | 208-230V, 1Ph, 60Hz |
| HSPF | 9.0 |
Installation must comply with national and local safety codes, including electrical requirements.
Criteria for selecting an appropriate outdoor location, considering airflow and structural support.
Safe practices for moving, lifting, and handling the unit during installation.
Minimum required clearances around the unit for proper operation, servicing, and airflow.
Instructions for unit conversion to downflow and ductwork design based on ACCA standards.
Information on filter inspection, replacement, and their impact on unit efficiency.
Requirements for installing the condensate trap and drain line according to local plumbing codes.
Identification of removable panels for accessing internal components and required service clearances.
Guidelines for thermostat placement and wiring to the unit for optimal control.
Procedures and safety requirements for field wiring, grounding, and circuit protection.
Wiring diagram and notes for connecting the thermostat and unit control system.
Diagram illustrating field power wiring, including disconnects and overcurrent protection.
Explanation of the anti-short cycle timer function and how to manually initiate a test cycle.
Step-by-step process of unit activation and operation during cooling mode.
Step-by-step process of unit activation and operation during heating mode, including auxiliary heat.
Details on the defrost cycle, its triggers, termination conditions, and manual initiation.
How safety switches protect the unit and the procedure for resetting lockout conditions.
Function of the electric heat limit switch, soft/hard lockout, and clearing lockout states.
Routine tasks including filter inspection, motor lubrication, and outdoor coil cleaning.
