Wired Controller DWUNI User Manual
5
3.2 On/Off
When the wired control is on main page, press ON/OFF button to turn on the unit.
Press ON/OFF button again to turn off the unit. The interfaces of On/Off status are
shown in Fig. 4 and Fig. 5.
Fig. 4 Off interface Fig. 5 On interface
3.3 Mode Setting
Under On status, pressing MODE button can set mode circularly as:
Note: If save function is on, auto mode is not available.
COOLING DRY FAN HEATING
3.4 Temperature Setting
Under unit on status, pressing “
ġ
” or “
Ģ
” button on the main page increases or
decreases set temperature by 1
(1
ć
); holding “
ġ
” or “
Ģ
” button increases or
decreases set temperature by 1
(1
ć
) every 0.3s.
In cooling,dry,fan and heating mode,temperature setting range is 61~86
(16ć
30ć). Under auto mode, set temperature cannot be adjusted.
AUTO
3.5 Fan Setting
Under On status, pressing FAN button can set fan speed circularly as:
LowĺMediumĺ+LghĺTurboĺ$utoĺLow
Symbols displayed are as shown in Fig. 6.
Fig. 6 Fan
setting
TURBO AUTO
To Next Page
Loading...
Need help?
General
