EasyManua.ls Logo

Johnson Controls S300 Series - Page 37

Johnson Controls S300 Series
46 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
S300-DIN-RDR2S Module Hardware Installation
24-10239-413 Rev. A 33
This document contains confidential and proprietary information of Johnson Controls, Inc.
© 2010 Johnson Controls, Inc.
OUT02 N/A SIO 2
General Purpose Output 4
Output is logically mapped to output
po
int 4. It can be timed, set, reset,
fast flag, or slow flash.
Output is an open collector that
switches to ground.
NC or
NO
Reader 2
Door Strike
Output is set every time an access
grant or auxiliary access occurs.
SIO 2
General Purpose Output 5
Output is logically mapped to output
point 5. It can be timed, set, reset,
fast flash, or slow flash.
Table 6: Output Point Signals (CK722 Controllers)
Signal
Names
Reader Terminal Object
Defined
Reader Terminal Object NOT
Defined
OUT11 Reader (Top)
Red Light Output
Output is set every time an access
de
ny occurs.
General Purpose Output OUT11
Output is logically mapped to
conn
ector OUT11. It can be timed,
set, reset, fast flash, or slow flash.
Output is an open collector that
switches to ground.
OUT12 Reader (Top)
Green Light Output
Output is set every time an access
grant occurs.
General Purpose Output OUT12
Output is logically mapped to
connector OUT12. It can be timed,
set, reset, fast flash, or slow flash.
Output is an open collector that
switches to groun
d.
OUT13 Reader (Top)
Shunt Output
Output is set every time an access
grant occurs.
General Purpose Output OUT13
Output is logically mapped to
conn
ector OUT13. It can be timed,
set, reset, fast flash, or slow flash.
Output is an open collector that
switches to groun
d.
OUT01 General Purpose Output OUT01
Output is logically mapped to
con
nector OUT01. It can be timed,
set, reset, fast flash, or slow flash.
Output is an open collector that
switches to groun
d.
General Purpose Output OUT01
Output is logically mapped to
conn
ector OUT01. It can be timed,
set, reset, fast flash, or slow flash.
Output is an open collector that
switches to groun
d.
Table 5: Output Point Signals (CK721-A/CK721/CK720/CK705 Controllers)
Signal
Names
RDR Mode Enabled SIO Mode Enabled

Other manuals for Johnson Controls S300 Series

Related product manuals