The Network Reset function resets Wi-Fi access point settings. Use this function if you forget your
Wi-Fi connection information. To reset the Wi-Fi access point settings, complete the following steps:
1. Press and hold the RESET button for two seconds. The FAULT LED flickers slowly.
2. Release the RESET button within three seconds. The FAULT LED continues to flicker slowly.
3. Within five seconds, press the RESET button again, and then immediately release it to
proceed with the reset. If you do not press the RESET button to confirm within five seconds,
the reset operation is canceled.
Result
The Wi-Fi access point SSID and passphrase are set to factory defaults. The LEDs stop flickering for
two seconds, then the LEDs return to normal operation based on the current state of the device.
Reset to factory defaults
About this task:
The Reset to Factory Defaults function resets all device settings including user profiles. The
function also resets your SSL certificate to the Johnson Controls self-signed certificate that is
included in the device. This function is for administrators who want to clear all user profiles from a
device. The Reset to Factory Defaults function does not change the version of the software. If you
run a software upgrade, the SBH300 retains the upgraded software version and does not reset to
the factory default version.
To reset to factory defaults, complete the following steps:
1. Press and hold the RESET button for six seconds. After two seconds, the FAULT LED flickers
slowly. After an additional four seconds of holding the RESET button, the FAULT LED changes
to a faster flicker.
2. Release the RESET button within three seconds of seeing a fast flicker. The FAULT LED
continues to flicker quickly.
3. Within five seconds, press the RESET button again, and then immediately release it to confirm
that you want to reset to factory defaults. If you do not press the RESET button to confirm
within five seconds, the reset operation is canceled.
Result
The Fault LED may flicker for up to eight minutes before all the LEDs turn on during reboot and
start-up. All device settings reset to factory defaults. The LEDs stop flashing for two seconds, and
then the LEDs return to normal operation based on the current state of the device.
Important: To access the SBH300 after a reset to factory defaults, you must use the default
log on credentials, see Factory default log on credentials. You can also find the default
credentials on the Smart Building Hub (SBH300) Quick Start Guide (Part No. A16381V57K) included
with the SBH300 and on the label on the back of the SBH300.
Factory default log on credentials
Table 5: Factory default credentials
Parameter Default
Wi-Fi access point SSID Verasys-SBH
Wi-Fi access point Passphrase SBH-xxxxxx. Where x represents the last six
digits of the MAC Address located on a label on
the back of the SBH300.
15Verasys Smart Building Hub (SBH300) Installation Guide
Johnson Controls
To Next Page
Loading...