DIN rail mounting
About this task:
To mount the SBH300 to a DIN rail, complete the following steps:
1. Securely mount a 190 mm (7.5 in.) or longer section of 35 mm (1.375 in.) DIN rail horizontally.
2. On the back of the SBH300, extend the two lower mounting clips.
3. Hang the top of the SBH300 to the DIN rail clip. Then press the SBH300 against the DIN rail
and hold in place while pushing up on the lower mounting clips to secure the unit.
Figure 1: SBH300 secured with mounting clips in latched positions
Wall mounting
1. Pull the bottom two mounting clips downward to their extended positions.
2. Mark mounting hole locations on the wall. Use the dimensions shown in Figure 2, or hold the
bracket against the wall and mark the hole locations through the mounting clips.
Note: The screw holes on the SBH300 can accommodate M4 and #8 screws.
3. Drill holes in the wall based on the locations marked in step 2. Insert wall anchors for each
hole if necessary.
4. Hold the device in place, insert the screws through the mounting clips and into the screw
holes, and then carefully tighten all screws.
Important: Do not overtighten the mounting screws. Overtightening the screws can
damage the mounting clips or bracket.
Verasys Smart Building Hub (SBH300) Installation Guide6
Johnson Controls
To Next Page
Loading...
Need help?
General
