Johnson Controls System 450 Series User Manual

System 450™ Series Control Module with Ethernet Communications Installation Instructions
29
Change Admin Password Screen: Allows you to change the Admin password. Enter your new Admin
password here. The Change Admin Password screen is identified by a 1 in superscript following AdMN.
Note: The factory-set default Admin Password is 1234. If you change the Admin password, record and
store the new password appropriately. If you do not recall the changed Admin password, you cannot
change the User or Admin passwords.
3. Press or to select the first digit of the new Admin password, then press
to save the selected
first digit and go to the second digit of the Admin password. Press or to select the second digit of
the Admin password, then press
to save the selected second digit and go to the third digit of the
Admin password. Repeat for the third and fourth digit of the Admin password. Then press
to save
the complete new Admin password.
This screen example shows the Admin password being changed to a new password.
Confirm New Admin Password Screen: Confirms the new Admin password entered in the previous
(Change Admin Password) screen. The Confirm Admin Password screen is identified by a 2 in the
superscript following AdMN.
4. Press or to select the first digit of the new Admin password, then press
to save the selected
first digit and go to the second digit of the Admin password. Press or to select the second digit of
the Admin password, then press
to save the selected second digit and go to the third digit of the
Admin password. Repeat for the third and fourth digit of the Admin password. Then press
to save
the complete new Admin password.
The screen example shows the new Admin password being entered in the Confirm Admin Password
screen.
Validate Admin Password Change Screen: Validates that the Admin Password was successfully
changed (OK).
5. Press to return to the Main screens
Note: If the value entered in the Confirm Admin Password screen does not match the value entered in
the Change Admin Password screen, validation fails (FAIL) and the Admin Password Setup Start
appears.
The top screen example shows the Admin password change is successful (OK). The bottom screen
example shows the Admin password change failed (FAIL).
Table 13: System 450 Administrator Password Setup Screen Information and Procedures (Part 2 of 2)
LCD Screen Name, Description or Function, User Action, and Example
FAIL

Johnson Controls System 450 Series Specifications

General

Brand	Johnson Controls
Model	System 450 Series
Category	Control Unit
Language	English