JOHNSON CONTROLS
2
FORM 150.62-NM6 (103)
2
GENERAL SAFETY GUIDELINES
This equipment is a relatively complicated apparatus. During installation, operation,
maintenance or service, individuals may be exposed to certain components or
conditions including, but not limited to: refrigerants, oils, materials under pressure,
rotating components, and both high and low voltage. Each of these items has the
potential, if misused or handled improperly, to cause bodily injury or death. It is the
obligation and responsibility of operating/service personnel to identify and recognize
these inherent hazards, protect themselves, and proceed safely in completing their
tasks. Failure to comply with any of these requirements could result in serious
damage to the equipment and the property in which it is situated, as well as severe
personal injury or death to themselves and people at the site.
This document is intended for use by owner-authorized operating/service personnel.
It is expected that this individual possesses independent training that will enable
them to perform their assigned tasks properly and safely. It is essential that, prior
to performing any task on this equipment, this individual shall have read and un-
derstood this document and any referenced materials. This individual shall also be
familiar with and comply with all applicable governmental standards and regulations
pertaining to the task in question.
SAFETY SYMBOLS
The following symbols are used in this document to alert the reader to areas of
potential hazard:
DANGER indicates an imminently hazardous situation which, if not avoided,
will result in death or serious injury.
WARNING indicates a potentially hazardous situation which, if not avoided,
could result in death or serious injury.
IMPORTANT!
READ BEFORE PROCEEDING!
To Next Page
Loading...
Need help?
General
