INSTALLATION
2-19
yellow (or orange) 8-pin siren pigtail of the trans-
ceiver (not the black 8-pin accessory pigtail).
NOTE: It is recommended that the power cable be
connected directly to the vehicle battery. Connection
to other locations may result in excessive noise in the
audio signal when using the PA function.
5. Connect the included fuseholder to the positive (+)
battery terminal using the included ring terminal or
another connector as required.
6. Connect the included red cable from the +12V
terminal on the amplifier to the fuseholder using the
included solder splice connector. This connector
contains internal solder that melts when heated
sufficiently.
7. Connect the included black cable from GND
terminal on the amplifier to the negative (–) battery
terminal using the included ring terminal or some
other connector as required.
8. Connect the loudspeaker to the SPEAKER termi-
nals on the amplifier using the included 2-conductor
cable and solder splice connectors (the order is not
important).
9. If the siren is to be automatically disabled when the
vehicle is in Park or Neutral, connect the black wire
coming from the siren controller connector to the
neutral safety switch.
10.If the vehicle horn is to sound with the siren, connect
the green wire coming from the siren control head
connector to the vehicle horn circuit.
To Next Page