whole wheel moves but the axle stays
in posion. If this is the case, use a set
of cone spanners to adjust or take to a
cycle mechanic to adjust.
• While wheel is in the fork move the
wheel side to side. If there is movement
in the Quick Release, then undo then
re-ghten aer reseang the wheel in
the drop out.
• Holding the rear wheels try to move
from side to side. Tighten the retaining
nuts with a 19mm socket.
• If bolts are ght but movement is seen
in the bearing have the bearing
replaced by a cycle mechanic.
To Next Page
Loading...
