Jorvik Jet-E1 - Page 42

Jorvik JMT Mid Drive Electric Mountain Trike
Page | 42
For the rear chain slacken the 6 frame assembly
bolts and pull the frame back and ghten up
with a 17mm socket and ring spanner.
Each chain should have a 2 to 3 mm of vercal
movement.
Wheel appears to move side
to side while riding.
• Tyre not seated on rim
correctly.
• Wheel is out of true.
• Axle is loose.
• Worn bearings in the
rear wheels.
• Rear wheel bolts not
ghtened.
• Remove the wheel and inspect the tyre.
Check that it is seated properly. If not,
then deate the tyre and press round
unl the bead of the tyre in in the rim
correctly. As you inate the tyre check
that tyre is sing properly in the rim.
• Spin the wheel in your hand or forks
and look at the rim for any up and
down or le to right deviaon (the tyre
may have some natural deformity so
ensure it is the rim you are looking at).
If there is, then true the wheel with the
tool provided or have it trued by a
bicycle mechanic.
• While the wheel is in the fork put le
and right pressure. Look to see if the