|
7ENGLISH
. QUICK START
1. Install batteries. (See Figure A)
2. Insert cuff air plug into the behind side of monitor unit. (See Figure B)
Fig. A Fig. B
3. Remove thick clothing from the arm area.
4. Rest for several minutes prior to testing. Sit down in a quiet place, preferably at a
desk or table, with your arm resting on a firm surface and your feet flat on the floor.
(See Figure C)
5. Apply cuff to your left arm and keep level with your heart. Bottom of cuff should be
placed approximately 1-2cm (0.4-0.8’’) above elbow joint. (See Figures D&E)
1–2 cm (0,4–0,8'')
Fig. D Fig. E
6. Press “ START/STOP “ Button to start testing.
To Next Page
Loading...
