JPT YDFLP - Operation Procedures and Precautions; Pre-Operation Checks; Laser Marking Operation; Operational Safety Precautions

YDFLP Fiber Laser Installation
Guide and User Manual
FileNumber:EFLP001‐B‐E ShenzhenJPTOpto‐electronicsCo.Ltd.
 Version：BDate:2016.4
19
4. Operation Procedure
4.1 Preparatory examination of the product
1）Check the laser casing and the fiber cable for any unexpected conditions;
2）Check the connection between laser system and the fiber laser module, and tighten the
connection cable.
4.2 Operation Procedure
1）Power on the system
Turn on the fiber laser at the same time or after turning on the marking machine. Wait for about
1 minute before move on to the next step. Please take note that the fiber laser will be locked
automatically if the laser control card has not been power on within 5s after turning on the laser.
If so, please restart the fiber laser in order to function normally.
2）Procedures for laser marking
To test the fiber laser, firstly please set the power to 0% and draw a simple figure using the laser
marking software, drive the marking and observe the laser output using the frequency doubling
piece of pottery and porcelain. Then gradually increase the laser power and change the settings
for the marking process. Under normal circumstances, the laser output observed using the
frequency doubling piece of pottery and porcelain should be stronger and stronger, or else, turn
down the machine and check it.
4.3 Precautions during the laser operation
1）Wear laser safety goggle;
2）Please stop the laser processing before turning off the fiber laser.
Product warranty and service terms above are for users’ reference only. Official service and
warranty scope will be specified in the contract.