JRC JCX-161 - Changing Password

Chapter 3 Operation
45
3.4.7 Changing password
The present password can be changed.
The default password is 0000. When using the system, make sure to change the password.
1） Call the SET VALUE screen in according to the procedure of the section “3.4.1 Call of menu
mode screen”.
2） Select [PASSWORD], and then press .
[PASSWORD] screen is displayed.
3） Input the new password.
Press , and then input the new 4 digit password.
After inputted the new password, press again, then its password is changed to the new
password.
When this setting change is canceled, press .
"0000" cannot be set to a password.