v
When the system is exposed to fresh water or seawater, wipe it immediately.
Otherwise, a failure or malfunction may occur.
When cleaning the system surface, do not use any organic solvent such as
thinner or benzine ; these solvents damage the surface coating.
To clean the surface, remove dust and debris then wipe it with a clean dry cloth.
Connect the ground wire to a grounded terminal. Otherwise, an electric shock
may occur as the result of a failure or earth leakage.
Avoid sharing a power source with a system that generates a large amount of
electronic noise (such as an air conditioner). The system may not function
properly because of short - time voltage drop or noise carried from power
Do not place the system on an unstable place such as a wobbly rack or incline.
The system may drop or tip over, resulting in personal injuries and/or
equipment failure.
Do not place the system in a place exposed to direct sunlight. Otherwise, it
may cause damage on the paint or seal on the surface.
Do not install the equipment near any radio equipment.
Otherwise, it may cause a signal reception might be affected.
To Next Page
Loading...
