JRC JHS-800S - 5 Settings & Registrations; Date and Time Setting

Settings & Registrations
5-1
5. SETTINGS & REGISTRATIONS
This chapter describes the procedure for settings and registrations for the date and time
manually, the contact lists for DSC calls, advanced DSC settings, and other settings for
the equipment.
5.1 Date and time setting
Normally, the date and time are updated automatically if importing GPS information. But if
necessary, input these parameters manually as follows.
■ Procedure ■
1
1
1
.
.
.
From the main menu, touch the [SETUP] →
[DATE&TIME] buttons.
2
2
2
.
.
.
Input the date and time information manually and then
touch the [✓] button to save them.
This menu includes the following settings
1. DATE & TIME SETTING
2. DISP FORM
TYPE： Indication type on the status
display from below;
TIME,POS/ TIME only/ POS only
UTC/LT： Universal Time Coordinated/ Local Time
LT DIFF： Setting of the time difference between UTC and LT
DATA FORMAT ： Date and time form on DSC messages and on an alarm history
from below;
'YY-MM-DD/ MMM DD,'YY/ DD MMM,'YY