JRC JHS-800S - Setting the Channel Area; Setting the S Meter Display

Settings & Registrations
5-8
5.3.7 Setting the channel area
This menu can select whether the current channel indication area on the status display is used as
the ten-key icon or not.
■ Procedure ■
1
1
1
.
.
.
From the main menu, touch the [SETUP] → [DISP SET]
→ [CH AREA] buttons.
Enter the setting as follows.
When using CH area as ten-key icon button: ON
When not using CH area as ten-key icon button: OFF
2
2
2
.
.
.
After inputting the setting, touch [✓ ] to save it.
5.3.8 Setting the S meter display
This menu can select whether the S meter, which indicates the receiving signal strength on the
status display, is used or not.
■ Procedure ■
1
1
1
.
.
.
From the main menu, touch the [SETUP] → [DISP SET]
→ [S METER] buttons.
Enter the setting as follows.
To make the S meter function valid: ON
To make the S meter function invalid: OFF
2
2
2
.
.
.
After inputting the setting, touch [✓ ] to save it.