JRC JHS-800S - Communicating with a PSTN Subscriber

Operation
4-22
4.3.5 Communicating with a PSTN subscriber
The semi/auto mode is used to connect with a public telephone network (PSTN) via a coast station.
(1) Make a call to a PSTN subscriber
■ Procedure ■
1
1
1
.
.
.
From the main menu, touch the [CALL] → [EDIT] →
[CALL TYPE] buttons.
2
2
2
.
.
.
Set the CALL TYPE to RTN/PSTN/RT as shown at right
and then touch the [✓ ] button,
3
3
3
.
.
.
The coast station list registered before is appeared as
shown at right (alphabetically sorted) and touch the
receiver station for the call.
If the coast station list is not registered, input manually.
The coast station list can be registered on the
COAST menu (MENU> SETUP> ADDR LIST).
4
4
4
.
.
.
Touch the [EDIT]→[TEL NO] buttons to display the
screen at lower right, and input the telephone number
to call.
If the telephone number is registered on the PSTN list
before, touch the [PSTN LIST] button to display the list.
The PSTN list can be registered on the PSTN
menu (MENU> SETUP> ADDR LIST).
Note
Note