JRC JHS-800S - Squelch Settings of each Channel (Preset Squelch)

Operation
4-15
4.2.11 Squelch settings of each channel (preset squelch)
The adjusted squelch value can be stored with respect to each channel as a preset squelch. The
handling of the preset squelch is as follows.
・ If stored the squelch value, the preset squelch is always set just after the channel selection.
・ While the preset squelch has been set, "PSQL" is indicated on the status display.
・ If turned the SQL control after setting the preset channel, the preset value is canceled
immediately and the SQL control is available.
・ The preset squelch value can be cleared with respect to each channel or each channel region.
■ Procedure ■
1
1
1
.
.
.
After setting the target channel for presetting as the
TRX channel of the marine VHF radio, from the main
menu, touch the [CH OPE] → [CH SQL SET] buttons.
2
2
2
.
.
.
Turn the SQL control to the appropriate position.
The SQL VALUE as shown at right is changed according to
the position of the knob.
3
3
3
.
.
.
Touch the [SET] button to complete the preset for the
squelch.
- To delete a preset squelch, set that channel and then touch the [ERASE] button
in the CH SQL SET menu above.
- To clear the preset squelch values for all the channels in a set region, touch the
[ALL CLEAR] button in the CH SQL SET menu above.
Note