4-45
[V] Satellite number setting (SBAS No.)
Set the satellite number.
This setting is enabled when satellite number select mode is set to manual.
Procedures 1. Press [RADA MENU] key.
The Main Menu will appear.
2. Press [7] key.
The NAV Equipment Setting screen will appear.
3. Press [7] key.
The GPS Setting screen will appear.
4. Press [3] key.
The SBAS Setting screen will appear.
5. Enter the satellite number.
Enter the number from 120 to 138.
6. Press the [6] key to send the setting value to SBAS receiver.
To Next Page
Loading...
Need help?
General
