Judo PROFI-PLUS - Product Information; Intended Purpose; Test Marks and Approvals; Materials Used

8 JUDO PROFI-PLUS
Product Information
3. Product Information
3.1 Intended purpose
This filter is suitable for use in cold drinking
water up to a water temperature of maxi-
mum 30°C (86°F).
ATTENTION
(see chapter “Safety information and dan-
gers due to non-compliance”)
Please refer to the chapter on “Intended
Use” for use restrictions.
This filter removes coarse and fine-grained
particles from the water which are larger
than or equal in size to the mesh size of the
filter.
3.2 Test marks
DIN-DVGW mark
The units conform to the technical regula-
tions for drinking water installations in ac-
cordance with DIN 1988. They are tested by
the DVGW (Deutsche Vereinigung des Gas-
und Wasserfaches e.V. technical –scientific
association for the gas and water industries)
in accordance with the requirements of DIN
19632 pressure stage PN 16 for mechanical
filters for use in drinking water and are enti-
tled to bear the DIN-DVGW mark (see fig.
2).
GS sign
In addition the filter has been checked by the
RWTÜV, and has been marked with the GS
sign for certified safety (see Fig. 4).
3.3 Materials used
The materials used are resistant to the phys-
ical, chemical, and corrosive loads to be ex-
pected in the drinking water and fulfil the re-
quirements specified in DIN 19632 (“Me-
chanical filters in drinking water installa-
tions”). All materials are hygienically and
physiologically safe. Plastics (KTW recom-
mendations) and metallic materials fulfil the
requirements of the BgVV (German Federal
Institute for Consumer Health Protection
and Veterinary Medicine).
Particles smaller than the supplied
mesh size and impurities causing
turbidity cannot be filtered out of the
water.
Fig. 3: Test marks
Fig. 4: RWTÜV