- 3 -
1. 仕様
1. SPECIFICATIONS
1. TECHNISCHE DATEN
DLN-9010ASS/SB DLN-9010ASH
用途 一般布はく・薄物・中厚物/低押え圧 厚物
縫い速度 最高 5,000sti/min 最高 4,000sti/min
最大縫い目長さ 4.5mm
(3.5mm 以上の場合、最高縫い速度は 4,000sti/min 以下です。)
使用針 DB × 1#9 〜 #18 DB × 1#20 〜 #23
押えの高さ(ひざ上げ) 10mm(標準)15mm(最大)
使用油 JUKI ニューデフレックスオイル No.1
騒音 JISB9064 に準拠した測定方法による「騒音レベル」
縫い速度= 5,000sti/min:騒音レベル≦ 84.0dBA(定常運転時
※1
)
縫い速度= 5,000sti/min:騒音レベル≦ 82.0dBA(付属装置作動時
※2
)
※1
定常運転時とは、直線縫い状態で装置などを作動させない状態で、一定速度で 300 mm縫製した際での騒音です。
※2
付属装置作動時とは、標準的な縫いパターンを自動バック・糸切り・ワイパーの装置を作動させて、300 mm縫製した際
での騒音です。
DLN-9010ASS/SB DLN-9010ASH
Application For general cloth, light- to medium-weight materials /
low presser foot pressure
Heavy-weight materials
Sewing speed Max. 5,000 sti/min Max. 4,000 sti/min
Stitch length Max. 4.5 mm
(The maximum sewing speed is less than 4,000 sti/min when the stitch length is 3.5 mm or less.)
Needle DB x 1 #9 to #18 (134 #65 to 110) DB x 1 #20 to #23 (134 #125 to 160)
Presser foot lift
(by knee lifter)
10 mm (standard) 15 mm (max.)
Lubricating oil JUKI New Defrix Oil No. 1
Noise
- Equivalent continuous emission sound pressure level (L
pA
) at the workstation :
A-weighted value of 80.0 dB; (Includes K
pA
= 2.5 dB); according to ISO 10821- C.6.2 -ISO 11204 GR2 at 4,800
sti/min.
DLN-9010ASS/SB DLN-9010ASH
Anwendung
Für allgemeine Gewebe, leichte bis mittelschwere Stoffe /
niedriger Nähfußdruck
Schwere Stoffe
Nähgeschwindigkeit Max. 5.000 sti/min Max. 4.000 sti/min
Stichlänge Max. 4,5 mm
(Bei einer Stichlänge von 3,5 mm oder mehr beträgt die maximale Nähgeschwindigkeit 4.000 sti/min.)
Nadel DB x 1 #9 bis #18 (134 #65 bis 110) DB x 1 #20 bis #23 (134 #125 bis 160)
Nähfußhub
(mittels Knielifter)
10 mm (normal), 15 mm (max.)
Schmieröl JUKI New Defrix Oil No. 1
Lärm - Entsprechender kontinuierlicher Emissions-Schalldruckpegel (L
pA
) am Arbeitsplatz:
A-bewerteter Wert von 80,0 dB; (einschließlich K
pA
= 2,5 dB); gemäß ISO 10821- C.6.2 -ISO 11204
GR2 bei 4.800 sti/min.
1. CARACTERISTIQUES
DLN-9010ASS/SB DLN-9010ASH
Application
Pour les vêtements en général, tissus légers à moyen /
pression du pied presseur faible
Tissus épais
Vitesse de couture 5.000 sti/min maxi 4.000 sti/min maxi
Longueur des points 4,5 mm maxi
(La vitesse maximale de couture est inférieure à 4.000 sti/min lorsque la longueur des points est 3,5 mm ou plus.)
Aiguille DB x 1 n°9 à 18 (134 n°65 à 110) DB x 1 n°20 à 23 (134 n°125 à 160)
Hauteur de relevage
du pied presseur
(avec la genouillère)
10 mm (standard) 15 mm (maxi)
Huile lubrifi ante JUKI New Defrix Oil No. 1
Bruit - Niveau de pression acoustique d’émission continu équivalent (L
pA
) au poste de travail :
Valeur pondérée A de 80,0 dB; (comprend K
pA
= 2,5 dB); selon ISO 10821- C.6.2 -ISO 11204 GR2 à
4.800 sti/min.