JUKI IP-100 - Before Setting the Pattern; Limitation of the Max. Zigzag Width

20
⇔
3
3
1
2
Max. zigzag width limitation value and reference of stitch base line are displayed when the
power is turned ON.
1： Max. zigzag width limitation value (Screen changes in case of specifying left/right positions.)
2：Reference of stitch base line
Max. zigzag width limitation value and reference of stitch base line can be performed with ON/OFF.
1
2
6-2. Before setting the pattern
WARNING :
Provide a clearance of 0.5 mm or more between the needle and the gauges when replacing the gauges
such as presser foot, throat plate, etc.
If the clearance is smaller than the specified value, it is in danger of
causing the needle to be broken or the like.
0.50.5
(1) Limitation of the max. zigzag width
• Max. zigzag width can be limited in accordance with the gauge.
• There are two kinds of limitations of max. zigzag width.
(1) Zigzag width symmetrical in the center
(2) Specifying left/right positions
■Changeover of limiting procedure of max. zigzag width limitation value
(2) Specifying left/right positions
(1) Zigzag width symmetrical in the center
1) Press switch 1.
2) Press switch 2.
3) Figure on the left side is the
zigzag width symmetrical in
the center mode.
Every time switch 3 is
pressed, specifying left/
right positions and zigzag
width symmetrical in the
center can be changed
over alternately.
Impor tant