56
The respective shapes of straight stitch, standard zigzag, 2-step zigzag, 3-step zigzag, scallop, blind stitch, and
custom can be registered in the pattern.
Patterns, the zigzag width of which is different from each other, and those, the positions of the stitch base line
of which are different from each other can be changed over and used without re-setting the data even in case
of the same zigzag shape by registering as patterns.
It is possible to register as many as 99 patterns.
(1) Setting the pattern stitching
Example) Scallop stitching
■The second screen of the sewing shape list
6-11. Pattern stitching
■Pattern selection pop-up screen
1) Select 1 in the
second screen of the
sewing shape list.
2) Press switch 2
corresponding to the
sewing which has been
registered, or the pattern
you desire to edit in the
pattern selection pop-up
screen.
3) Press to display the
sewing shape setting
screen.
1
2
5) When all inputting procedures have been completed, press key to determine.
When the power source is turned OFF without pressing key, the inputted data returns
to the former one. When you desire to determine the data, be sure to press key.
Feed direction of all of the condensation custom patterns is in the reverse feed direction.
Impor tant
Standard delivery level of the key lock is “1”. When the level of the key lock is the case
other than “0”, be sure to change the level to “0” to perform the operation below.
Impor tant
Cau tion
To Next Page
Loading...
