JUKI IP-100 - Page 78

72
1
2
■
Warning screen
Warning screen is displayed when the warning time is reached.
■Clear screen
1 : The screen returns to the maintenance function screen without performing clearing.
2 : The screen returns to the maintenance function screen after executing clearing.
1 : When 1 is pressed, the screen can be cleared. However, the counter itself cannot be cleared. In case of
the replacement of needle, the warning screen is displayed at intervals of 10 minutes until clearing is
performed. In case of other warnings, the warning screen is displayed at the time of turning ON the power
until the counter is cleared.
2 : When 2 is pressed, the screen is cleared and the counter value is cleared as well. From this time, counting
starts newly.
1
2
[Setting of the warning setting time]
■Infomation screen
1) Press switch 1 for approximately three seconds in the information screen.
1