Maintenance Guide
iv
5-6. Replacing the WAIT Sensor ............................................................................... 5 - 6
5-6-1. Replacing the Fiber ........................................................................................................... 5-6
5-6-2. Replacing the Amplifier Unit .............................................................................................. 5-7
5-7. Replacing the STOP and C. OUT Sensors ......................................................... 5 - 8
5-8. Replacing the Stopper Cylinder .......................................................................... 5 - 9
5-9. Replacing the Support Table Home Position Sensor
(BU Home Position Sensor) .............................................................................. 5 - 10
5-10. Replacing the T-PIN Sensor (Optional) ............................................................ 5 - 11
5-11. Replacing the Pusher Y Cylinder (Outer Shape Reference) ............................. 5 - 12
5-12. Replacing the Pusher X Cylinder (Outer Shape Reference/Optional Unit) ....... 5 - 13
5-13. Replacing the Pressure Reducing Valve .......................................................... 5 - 13
5-14. Replacing the Centering Pin (Option) ............................................................... 5 - 14
5-15. Replacing the Support Table Motor (BU Motor) ................................................ 5 - 15
5-15-1. Adjusting the Gap between Torque Supporter and Support Motor .................................. 5-15
5-15-2. Adjusting the Tension of the Support Table Driving Timing Belt .................................... 5-16
5-15-3. Placing the Support Table Surface Horizontally ............................................................. 5-17
5-16. Replacing the Support Table ENC .................................................................... 5 - 18
5-17. Backup Stopper (for CE Type Only) ................................................................. 5-19
5-18. Solenoid Valve .................................................................................................. 5 - 20
5-18-1. Solenoid Valve (KE-1070C) ............................................................................................ 5 -20
5-18-2. Solenoid Valve (KE-2070/2080/2080R/1080) ................................................................. 5-21
[6] CAL BLOCK ...................................................................................... 6-1
6-1. Replacing the CAL Block Board Assembly ......................................................... 6 - 1
6-2. Replacing the Ejector ......................................................................................... 6 - 2
6-3. Replacing the Load Cell...................................................................................... 6 - 3
[7] ATC ................................................................................................... 7-1
7-1. Replacing the Air Cylinder .................................................................................. 7 - 1
7-2. Replacing the ATC OPEN and CLOSE Sensors ................................................ 7 - 4
7-3. Adjusting the Speed Controller ........................................................................... 7 - 4
[8] VCS ................................................................................................... 8-1
8-1. Replacing the CCD Camera Lens
(It is recommended to replace the VCS camera assembly.) ............................... 8 - 1
8-2. Replacing the Standard VCS䲑Optional VCS Switching Cylinder ...................... 8 - 3
8-3. Replacing the Light Boards................................................................................. 8 - 4
8-3-1. Transmission Light Board, Coaxial Light Board ................................................................ 8-4
8-3-2. Downward Light Board, Side Light Board ......................................................................... 8-5
To Next Page
Loading...
Need help?
General
