To Next Page

To Previous Page

Maintenance Guide

13-3. Replacing the LCD Monitor............................................................................... 13-7

13-3-1. Replacing the LCD Monitor ............................................................................................. 13-7

13-3-2. Replacing the Backlight of the LCD Monitor ................................................................. 13-10

13-3-3. Jumper settings for RS232C CHANGE PCB ASM ....................................................... 13-11

13-3-4. Setup and connection when the optional rear monitor is used ..................................... 13-12

13-4. Replacing the System Disk ............................................................................. 13-14

13-4-1. Replacing the SSD ........................................................................................................ 13-14

13-4-3. Setting Up the BIOS ...................................................................................................... 13-16

13-4-4. Setting Up the Network

(This setup is performed when communicating with the HLC) ..................................... 13-24

13-4-5. Installing the KE2000-series System Programs and Flexline DB ................................. 13-34

13-4-6. Upgrading the System Version...................................................................................... 13-43

13-5. Replacing the Load Cell Amplifier (Optional Unit) ........................................... 13-47

[14] ELECTRICAL COMPONENTS ........................................................ 14-1

14-1. Layout of Electrical Components ...................................................................... 14-1

14-1-1. Part Names (KE-1070/1070C/1080) ............................................................................... 14-1

14-1-2. Part Names (KE-2070/2070C/2080/2080R) ................................................................... 14-2

14-2. Layout of Top of Base Frame ........................................................................... 14-3

14-2-1. Part Names ...................................................................................................................... 14-3

14-3. Power Supply Unit ............................................................................................ 14-4

14-3-1. Structure of Power Supply Unit ....................................................................................... 14-4

14-4. Control Unit ..................................................................................................... 14-12

14-4-1. Structure of Control Unit ................................................................................................ 14-12

14-4-2. CPU Board (Old Board: 40044475, New Board: 40107372) ........................................ 14-15

14-4-3. Position Board (40044540) ............................................................................................ 14-17

14-4-4. IEEE1394A Board (40150021) ...................................................................................... 14-18

14-4-5. Bus Bridge Board (40003313)

....................................................................................... 14

-19

14-4-6. SAFETY Board (40136685) .......................................................................................... 14-20

14-4-7. BASE FEEDER Board Assembly (40001941) .............................................................. 14-24

14-4-8. I/O Control Board Assembly (40001943) ...................................................................... 14-26

14-4-9. Adjusting the Light Ctrl Board Assembly (40001904)

and Light Ctrl Board (50) Assembly (40001918) .......................................................... 14-28

14-4-10. IP-X3R Board Assembly DIP switches settings ............................................................ 14-29

14-4-11. XY Relay Board (40044557) ......................................................................................... 14-30

14-4-12. I-CX Board Assembly (40031754) ................................................................................ 14-31

14-4-13. MCM (Multi Nozzle Control Module) Board (E9610729000) (KE-2080R Only) ............ 14-33

JUKI KE-2080 Maintenance Guide

Other manuals for JUKI KE-2080