– 8 –
(3) Crank connecting rod connection / disconnection
Procedures of disassembling
1. Remove the two set screws and four set screws . Then take out the lengthwise feed motor and the
crosswise feed motor mounting plate .
2. Loosen the three set screws and the two set screws . At that time, the second screws should be
loosened first for the set screws and . The first screws of the set screws and should be arranged
so that they can come completely off the flat section of the oscillator shaft .
3. Pull out the oscillator shaft in the direction of the arrow A.
4. Remove the main shaft according to [(1) Main shaft connection/ disconnection]. Then, take out the crank
rod unit .
34.1~34.6mm
Face B
No. 2 screw
No. 1 screw
D
E
A
C
No. 2 screw
No. 1 screw
No. 2
screw
No. 1 screw
To Next Page
Loading...
