– 90 –
Machine lock error The main shaft of the sewing machine Turn OFF the power switch and remove
does not rotate due to some troubles. the cause of troubles.
Pattern No. error Back-up pattern No. has not been registered
Press the reset switch and check the pattern No.
in the data ROM, or it is set to readout Check the contents of memory switch No. 201.
inoperative.
Pattern No. is set at “0”.
Needle bar UP position Needle bar is out of the needle UP position. Turn the hand pulley to return the needle
error bar to its UP position.
Sewing area over The sewing area is beyond the limit. Press the reset switch and check the This error is output when
pattern and X/Y scale rate. max. sewing area, 30 x 40
is over. Interference of the
work clamp foot with needle
is not protected
Enlargement error The sewing pitch is beyond 10mm. Press the reset switch and check the
pattern and X/Y scale rate.
Pattern data error The pattern data cannot be adopted. Turn OFF the power switch and check the
data ROM.
Temporary stop Temporary stop by operating the reset switch Re-start or return-to-origin after thread
while the sewing machnine is running. trimming by means of the reset switch (For
(Refer to memory switch No. 31.) the details, refer to the item “Using the
temporary stop function”, P.29.)
Notice for the grease Indicates that it is the time to replenish Replenish the grease to the specified part 9. Refer to Maintenance
replacement time grease to the specified parts. and set the memory switch No. 245 at [0] (5) “Replenishment of
with the reset key. If the grease cannot be grease-up procedures for the
fed soon in the middle of sewing work, the specified position.”
error can be canceled by means of the reset key.
Grease replenishment alarm The sewing machine stopped due to the Replenish the grease immediately and set 9. Refer to Maintenance
error expiration of grease replenishment time to the memory switch No. 245 at [0] with the (5) “Replenishment of
the specified parts. reset key. grease-up procedures for the
specified position.”
Head tilt error Head tilt detection switch is turned ON. The sewing machine cannot be operated
withe the head tilted.
Return the sewing machine head to its
proper position.
Indication Name of error Description of error Corrective measure Remarks
10. Table of errors
To Next Page
Loading...
