JUKI LK-1900A Series - Adjusting the Lift of the Work Clamp Foot; Adjusting the Thread Trimmer Sensor

– 20 –
(13) Adjusting the lift of the work clamp foot
Standard Adjustment
(14) Adjusting the thread trimmer sensor
Standard Adjustment
Max. 17mm
After the completion of origin retrieval in the test mode CP-6 (Start Switch ON), try to press the + key 6 to 8
times. At that time, the thread trimmer sensor is turned ON. (The digit display at the operation panel: [10] →
[00])
B
A
C