JUKI LU-2810 Series - 8. Machine Head Wiring (with Thread Trimmer); Connectors from Machine Head to Control Box

– 58 –
8. Machine head wiring (for the machine with thread trimmer only)
(1) Connectors coming from machine head (Connect to control box)
o
CN36 : 14P connector
Pin No. Part name Remarks
1 Thread release solenoid (lower side)
2 Thread release solenoid (upper side)
3 — —
4 Knee switch
5 Reverse feed switch
6 Thread trimmer solenoid (left side)
7 Thread trimmer solenoid (right side)
8 Thread release solenoid (lower side) +27V
9 Thread release solenoid (upper side) +27V
10 FG FG
11 Knee switch GND
12 Reverse feed switch GND
13 Thread trimmer solenoid (left side) +27V
14 Thread trimmer solenoid (right side) +27V
o
CN37 : 2P connector
Pin No. Part name Remarks
1 — —
2 — +27V
o
CN44 : 24P connector
Pin No. Part name Remarks
1 6-operation switch +5V
2 6-operation switch +5V
3 — +12V
4 6-operation switch Alternate vertical movement switch
5 6-operation switch Automatic reverse feed stitching cancellation switch
6 6-operation switch Needle up/down switch
7 6-operation switch 2-pitch changeover switch
8 6-operation switch Tension release (upper side) opening switch
9 6-operation switch —
10 6-operation switch Fall detection sensor
11 6-operation switch —
12 6-operation switch GND
13 6-operation switch GND
14 — —
15 6-operation switch Alternate vertical movement state monitor output
16 6-operation switch Automatic reverse feed stitching cancellation state monitor output
17 6-operation switch Needle up/down correction operation output
18 6-operation switch 2-pitch state output
19 6-operation switch Tension increasing state monitor output
20 — —
21 — —
22 — —
23 — —
24 — —
海外講習会用121122LU-2810(-7)EM