Maintenance
29
7.4 Clean device
The outside of the device should be periodically cleaned.
Lint-free cloth
Mild cleaning agent
Damage to the electronics due to water penetration!
Ingress of water can damage electronic components of the device and thus
lead to failure of the device.
• Clean the outside of the device with a damp cloth only
• Prevent water from entering the device
1. Clean the surface of the device with a damp cloth.
Some dish detergent may also be used for cleaning. If in doubt, ask
technical service for alternative cleaning mediums.
The device has now been cleaned.
7.5 Cleaning condenser
From time to time, the condenser on the front of the device should be cleaned
to maintain full cooling capacity.
Risk of fire with flammable refrigerants!
If the device contains a flammable refrigerant, there is a risk of fire if the
refrigerant circuit leaks.
• Do not damage the refrigerant lines
• Do not damage the condenser fins
• If refrigerant escapes, switch off the device immediately, keep open
flames and sources of ignition away, and ventilate the room well
The device is switched off.
1. Allow the device to cool down to room temperature.
2. Take the venting grid off the front of the device.
To Next Page
Loading...
