4
7.3.1 Connect an external system with screw connections .............. 36
7.3.2 Connect an external system with barbed fittings...................... 37
7.4 Set high temperature safety function ............................................. 38
7.5 Fill device ....................................................................................... 39
7.6 Set up power supply for the refrigerated circulator ....................... 40
7.7 Adjusting the flow of the bath fluid ................................................. 40
7.8 Set chiller mode ............................................................................. 41
8 Operation ........................................................................................... 42
8.1 Switch on the unit .......................................................................... 42
8.2 Switch off the unit .......................................................................... 42
8.3 Configuring setpoint temperature .................................................. 42
8.4 Start temperature control application ............................................ 43
8.5 Activate autostart function ............................................................. 43
8.6 Record data ................................................................................... 44
8.6.1 Record measurement data ....................................................... 44
8.6.2 Reading out blackbox data ....................................................... 44
8.7 Remote control device ................................................................... 44
8.8 Setting the timer ............................................................................ 45
8.9 Adjusting the temperature sensor (ATC) ....................................... 46
9 Maintenance ...................................................................................... 47
9.1 Check safety symbols.................................................................... 47
9.2 Check the functionality of high temperature cut-off ....................... 47
9.3 Test the low liquid level safety function ......................................... 47
9.4 Replace detachable power cord .................................................... 48
9.5 Emptying ........................................................................................ 48
9.6 Clean device .................................................................................. 49
9.7 Device storage ............................................................................... 49
9.8 Technical Service .......................................................................... 50
9.9 Warranty ........................................................................................ 50
10 Disposal ............................................................................................. 53
10.1 Device disposal ............................................................................. 53
11 Appendix ........................................................................................... 54
11.1 Interface commands ...................................................................... 54
11.1.1 IN commands ........................................................................... 55
To Next Page
Loading...
