E 13
0803.GB
Driving
f
Do not drive the truck unless the hoods are closed and locked in the stipulated man-
ner.
Always lower the load when driving outside the aisles.
Always follow the operational sequences described below.
– Start up the truck (refer to section 3).
– Press the deadman key (11).
A
Heed the steering position of the drive wheel shown on the information and service
display (4). The acceleration rate can be set at the information and service display by
the operator.
– Set the controller (1) to the required travelling direction: forwards (V) or reverse (R).
The truck will move in the selected direction.
The travelling speed is controlled by means of the controller.
A
If the driver stand platform is lifted to a height above 1200 mm
– the speed is reduced to 2.5 km/h (cut-back speed).
o If, during auxiliary lifting (o), the driver stand platform is lifted to a height above
450 mm
– the speed is reduced to 2.5 km/h (cut-back speed).
1
0
43
24
16
R
R
V
V
26
0
V
R
E 13
0803.GB
Driving
f
Do not drive the truck unless the hoods are closed and locked in the stipulated man-
ner.
Always lower the load when driving outside the aisles.
Always follow the operational sequences described below.
– Start up the truck (refer to section 3).
– Press the deadman key (11).
A
Heed the steering position of the drive wheel shown on the information and service
display (4). The acceleration rate can be set at the information and service display by
the operator.
– Set the controller (1) to the required travelling direction: forwards (V) or reverse (R).
The truck will move in the selected direction.
The travelling speed is controlled by means of the controller.
A
If the driver stand platform is lifted to a height above 1200 mm
– the speed is reduced to 2.5 km/h (cut-back speed).
o If, during auxiliary lifting (o), the driver stand platform is lifted to a height above
450 mm
– the speed is reduced to 2.5 km/h (cut-back speed).
1
0
43
24
16
R
R
V
V
26
0
V
R
To Next Page
Loading...
Need help?
General
