Completing battery charging, restoring the truck to operation
NOTICE
If charging has been interrupted, the full battery capacity will not be available.
Requirements
– The battery is fully charged.
Procedure
• Remove the mains connector (51) from the mains socket and store it along with
the cable in the storage compartment (50).
• If applicable, place the existing insulating mats back over the battery.
• Close the battery panel securely.
The truck is now ready for operation.
CAUTION!
Damaged mains cables can be hazardous
u
Do not trap the mains cable when closing the battery panel.
Charging times
The duration of charge depends on the battery capacity.
Z
Charging continues automatically after a mains failure. Charging can be interrupted
by removing the mains connector and continued as partial charging.
53
04.19 en-GB
To Next Page
Loading...
Need help?
General
