5.3 Restoring the truck to service after decommissioning
Procedure
• Thoroughly clean the truck, see page 155.
• Lubricate the truck according to the lubrication schedule, see page 152.
• Clean the battery, grease the terminal screws and connect the battery.
• Charge the battery, see page 45.
• Start up the truck, see page 67.
WARNING!
Faulty brakes can cause accidents
As soon as the truck has been started, test the brakes several times.
u
Report any defects immediately to your supervisor.
u
Tag out and decommission the faulty industrial truck.
u
Only return the truck to service when you have identified and rectified the fault.
Z
If there are switching problems in the electrical system, apply contact spray to the
exposed contacts and remove any oxide layers on the contacts of the controls by
applying them repeatedly.
168
04.19 en-GB
To Next Page
Loading...
Need help?
General
