4.5 Tightening the wheel nuts
Z
The wheel nuts on the drive wheel must be retightened in accordance with the
maintenance intervals indicated in the maintenance checklist, see page 125.
Tightening the wheel nuts
Requirements
– Prepare the truck for maintenance and repairs, see page 113.
Tools and Material Required
– Torque wrench
Procedure
• Position the drive wheel (96) so that the wheel nuts (95) can be pulled through the
hole (94).
• Tighten all the wheel nuts (95) through the hole (94) in the impact buffer with the
socket wrench.
To do this, tighten the wheel nuts in the prescribed order.
• First of all tighten to 10 Nm.
• and then to 150 Nm.
The wheel nuts have now been tightened.
119
04.19 en-GB
To Next Page
Loading...
Need help?
General
