Juniper ACX5448 - Page 20

Figure 36: Power Cord Retainer Port on the AC PSM for ACX5448
g100048
1
2
3
4
5
4—1— Ejector leverInput status LED
5—2— AC power cord retainer portOutput status LED
3—Fault LED
Figure 37 shows the power cord retainer installed on the AC PSM for ACX5448 router.
Figure 37: Power Cord Retainer Installed on the AC PSM for ACX5448
g009866
1
2
3
5
4
4—1— AC power cord retainer installedInput status LED
5—2— Ejector leverOutput status LED
3—Fault LED
5. Press the small tab on the retainer strip to loosen the loop. Slide the loop until you have enough space to insert the
power cord coupler into the inlet.
6. Insert the power cord coupler firmly into the inlet.
7. Slide the loop toward the PSM until the loop is snug against the base of the coupler.
8. Press the tab on the loop and draw out the loop into a tight circle (see Figure 38).
9. Route the power cord appropriately. Verify that the power cord does not block the air exhaust and access to router
components, or drape where people could trip over it.
20