Juniper CTP2000 Series - SSH Access; Power On Device

To Next Page

To Previous Page

Please remove the old flash, hit return when finished.

Migrating system ID to new flash.

* The system will reboot when finished.

INIT: Sending processes the TERM signal

Gathering system information.

* Please wait this could take up to 45 seconds.

Found:

System type PP310

Bios 2.21

Memory installed 1024 MB

Slot 0: Type T1E1

FPGA 0xea * needs 0xea

Slot 1: Type Serial

FPGA 0x73

Slot 2: Type FXS

FPGA 0x5010150

ID restored Yes

Hit return to continue...

Restarting syslog.

. done.

Upgrading T1E1 card in slot 0 to FPGA rev 0xea.

Upgrading FPGA on card 0. Please wait for completion.

. done.

Upgrading FPGA on card 0 complete.

Upgrading Winmon. Please wait for completion.

..... . done.

Upgrading Winmon complete.

Upgrading Daughter cards. Please wait for completion.

. done.

Upgrading Daughter cards complete.

**** ****

Finished preparing system for running CTPOS 6.0R1.

Finished migrating ID from CTPOS . Reboot required.

**** ****

Please verify that all circuits and system setting are

correct after the system reboots.

**** ****

Hit return to reboot the system.

Upgrading the CTP2000 Series Device to CTPOS 7.x

Other manuals for Juniper CTP2000 Series